Toro 30605 Operator's Manual page 27

Figure 16
5. Push the castor spindle through the front castor arm.
6. Install the shims (as they were originally installed) and
the remaining spacers onto the spindle shaft.
7. Install the tensioning cap to secure the assembly.
8. Remove the hairpin cotter and clevis pin securing the
height-of-cut chains to the rear of the cutting unit
(Figure 17).
Figure 17
1. Height-of-cut chain
9. Mount the height-of-cut chains to the desired
height-of-cut hole (Figure
hairpin cotter.
Figure 18
Note: When using 25 mm (1 inch), 38 mm (1-1/2
inch), or occasionally 51 mm (2 inch) height-of-cut,
move the skids and gage wheels to the highest position.
2. Clevis pin and hairpin
cotter
18) with the clevis pin and
Side Cutting Units
To adjust the height-of-cut on the side cutting units, add
or remove an equal number of spacers from the castor
forks, position the castor wheel axles in the high or low
height-of-cut holes in the castor forks, and secure the pivot
arms to the selected height-of-cut bracket holes.
1. Position the castor wheel axles in the same holes in all
of the castor forks
the following chart to determine the correct hole for
the setting.
1. Tensioning cap
2. Spacers
3. Shims
2. Remove the tensioning cap from the spindle shaft
(Figure 19) and slide the spindle out of castor arm.
3. Put the 2 shims onto spindle shaft as they were
originally installed.
Note: These shims are required to achieve a level
across the entire width of the cutting units. Slide the
appropriate number of 13 mm (1/2 inch) spacers onto
the spindle shaft to get the desired height-of-cut; then
slide the washer onto the shaft. Refer to the following
chart to determine the combinations of spacers for
the setting.
4. Push the castor spindle through the castor arm.
27
(Figure 19 and Figure 21). Refer to
Figure 19
4. Top axle-mounting hole
5. Castor wheel
Figure 20