Toro 30605 Operator's Manual page 19

InfoCenter Icon Description (cont'd.)
Denied or not allowed
Engine start
PTO-indicates that the PTO is On
Stop or shutdown
Engine
Key switch
Indicates when the cutting units are
being lowered
Indicates when the cutting units are
being raised
PIN passcode
Hydraulic-Oil Temperature-indicates
the temperature of the hydraulic oil
CAN bus
InfoCenter
Bad or failed
Center
Right
Left
Bulb
Output of TEC controller or control
wire in harness
High: over-allowed range
Low: under-allowed range
Out of range
/
Switch
Operator must release the switch
InfoCenter Icon Description (cont'd.)
Symbols are often
combined to form
sentences. Some
examples are shown
below
Using the Menus
To access the InfoCenter menu system, press the menu access
button while at the main screen. This will bring you to the
main menu. Refer to the following tables for a synopsis of
the options available from the menus:
Main Menu
Menu Item
Faults
Service
Diagnostics
19
Operator should change to the
indicated state
Operator should put machine in
neutral
Engine start denied
Engine shutdown
Engine coolant is too hot
Hydraulic oil is too hot
Sit down or set the parking brake
Description
The Faults menu contains
a list of the recent machine
faults. Refer to the Service
Manual or your Authorized
Toro Distributor for more
information on the Faults
menu and the information
contained there.
The Service menu contains
information on the machine,
such as hours of use and other
similar numbers.
The Diagnostics menu
displays the state of each
machine switch, sensor and
control output. You can use
this to troubleshoot certain
issues, as it will quickly tell you
which machine controls are on
and which are off.