1. Engine guard
2. Engine air intake screen
3. Bolt
Checking and Cleaning the
Hydraulic-Unit Shrouds
Service Interval: Before each use or daily
Important: The fasteners on the covers of this machine
are designed to remain on the cover after removal.
Loosen all of the fasteners on each cover a few turns so
that the cover is loose but still attached, then go back
and loosen them until the cover comes free. This will
prevent you from accidentally stripping the bolts free
of the retainers.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Move the seat all the way forward.
4. Allow the engine and the hydraulic system to cool.
5. Clean the debris and grass from the hydraulic-unit
shrouds
(Figure
72).
Figure 71
4. Fan housing
5. Screw
1. Hydraulic-unit shrouds
6. Over each dipstick, remove the cover and the bolt
attached to the cover . Clean around each dipstick and
hydraulic unit
(Figure
7. Install the cover over each dipstick.
8. Adjust the seat.
1
1. Cover
49
Figure 72
73).
2
Figure 73
2. Bolt
G012434