Servicing the Fuses
The electrical system is protected by fuses. It requires no
maintenance; however, it a fuse blows, check the component
or the circuit for a malfunction or short.
1. The fuses are located on right-hand console next to
the seat (Figure 62).
2. To replace a fuse, perform the following:
A. Pull the damaged fuse out of the socket.
B. Insert the new fuse into the socket (Figure 62).
Figure 62
1. Optional accessory
(15 amp fuse)
2. Charge (25 amp fuse)
3. PTO (10 amp fuse)
4. Main (25 amp fuse)
5. Console
Drive System
Maintenance
Adjusting the Tracking
1. Disengage the blade control switch (PTO).
2. Drive to an open flat area, move the motion control
levers to the neutral locked position.
3. Move the throttle midway between fast and slow.
4. Move both motion control levers all the way forward
until they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If it tracks to the right, loosen the bolts and adjust
the left stop plate on the left T-slot until the machine
tracks straight.
7. If it tracks to the left, loosen the bolts and adjust the
right stop plate on the right T-slot until the machine
tracks straight.
8. Tighten the stop plate.
Left control lever shown
1. Control lever
2. Bolt
43
g019756
Figure 63
3. Stop plate