Cleaning; Cleaning Under The Mower; Waste Disposal - Toro 74902TE Operator's Manual

6 2
1
g015594
Figure 102
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Place the spacer and spring onto the grass deflector.
Place one J end of the spring behind the deck edge.
Note: Make sure one J end of the spring is installed
behind the deck edge before installing the bolt as
shown in Figure 102.
3. Install the bolt and nut. Place one J hook end of the
spring around the grass deflector (Figure 102).
Important: The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the full
down position.
4
7
3
5
5. Spring installed
6. Grass Deflector
7. J hook end of spring

Cleaning

Cleaning Under the Mower

Service Interval: Before each use or daily
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Raise the mower to the transport position.

Waste Disposal

Engine oil, batteries, hydraulic oil, and engine coolant are
pollutants to the environment. Dispose of these according to
your state and local regulations.
62