Check And Clean The Hydraulic Unit Shrouds - Toro 74902TE Operator's Manual

1. Engine guard
2. Engine air intake screen
3. Bolt
Check and Clean the Hydraulic
Unit Shrouds
Service Interval: Before each use or daily
Important: The fasteners on the covers of this machine
are designed to remain on the cover after removal.
Loosen all of the fasteners on each cover a few turns so
that the cover is loose but still attached, then go back
and loosen them until the cover comes free. This will
prevent you from accidentally stripping the bolts free
of the retainers.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Move the seat forward.
4. Allow the engine to and hydraulic system to cool.
5. Clean the debris and grass from the hydraulic unit
shrouds (Figure 74).
Figure 73
4. Fan housing
5. Screw
1. Hydraulic unit shrouds
6. Over each dipstick, remove the cover and the bolt
attached to the cover . Clean around each dipstick and
hydraulic unit (Figure 75).
7. Position the seat.
1
1. Cover
48
Figure 74
2
Figure 75
2. Bolt
G012434