Toro 30411 Groundsmaster 4100-D Operator's Manual page 25

Figure 18
1. Castor wheel
2. Tensioning cap
3. Spacers
Refer to the following chart to determine the
combinations of spacers for the setting.
Figure 19
3. Push the castor spindle through the castor
arm. Install the shims (as originally installed)
and the remaining spacers onto the spindle
shaft. Install the tensioning cap to secure the
assembly.
4. Remove the hairpin cotter and clevis pins from
the castor pivot arms (Figure 20).
5. Rotate tension rod to raise or lower pivot
arm until holes are aligned with selected
4. Shims
5. Axle mounting holes
height-of-cut bracket holes in the cutting unit
frame (Figure 20 and Figure 21).
6. Insert the clevis pins and install the hairpin
cotters.
7. Rotate tension rod counterclockwise (finger
tight) to put tension on adjustment.
Figure 20
1. Castor pivot arm
2. Axle mounting holes
Figure 21
Adjusting the Skids
The skids should be mounted in the lower position
when operating in height of cuts greater than
2-1/2 inches (64 mm) and in the higher position
when operating in height of cuts lower than 2-1/2
inches (64 mm).
Adjust the skids by removing the flange bolt and
nuts, positioning them as desired, and installing
the fasteners (Figure 22).
25
3. Clevis pin and hair pin
cotter
4. Tension rod