System Data Control; Pc Programming - Panasonic KX-TDA15 Features Manual

2.3 System Data Control

2.3 System Data Control
2.3.1

PC Programming

Description
This PBX can be programmed and administered using a PC. There are two programming methods:
1)
On-site Programming: System programming/diagnosis can be performed locally by connecting a
PC to the PBX directly.
2)
Remote Programming: System programming/diagnosis and data upload can be performed from
a remote location.
1.
On-site Programming:
Using the Serial Interface (RS-
232C) port
Using the USB port
Using the LAN interface
Using an ISDN TA interface
(64 kbps) through an ISDN
Extension Line
2.
Remote Programming:
Using an external modem
Using an ISDN TA interface
(64 kbps) through an ISDN
Trunk
380 Feature Guide
Method
Method
An external modem can be used to perform the remote programming.
An external modem can be connected to the Serial Interface (RS-
232C) of the PBX. Connect the modem to an extension port which is
assigned as the DIL/DID/DDI/MSN destination or to a trunk directly
to connect to the PBX from the PC. An AT command can be sent to
the modem automatically when it is connected to the Serial Interface
(RS-232C) port. AT commands can be programmed beforehand
through system programming to initialise the modem. An AT
command can also be sent manually in the PT system programming
mode.
The floating extension number of the ISDN remote maintenance must
be assigned (default: 699), and dial the DIL/DID/DDI/MSN number
whose destination is the floating extension number of the ISDN
remote maintenance.
This method is available only when an user-supplied ISDN TA that
supports CAPI is used.
The PBX has a Serial Interface (RS-232C) port which can be used
for either system administration or SMDR (→ 1.22.1 Station Message
Detail Recording (SMDR)).
The PC is connected to the USB port of the PBX, or a USB port (USB
Module) attached to a DPT.
An IP-GW4 card must be installed.
Assign the floating extension number of the ISDN remote
maintenance (default: 699), and dial this number from the PC to
connect to the PBX.
This method is available only when a user-supplied ISDN TA that
supports CAPI is used.
Description
Description