Bosch PTK 3,6 LI Original Instructions Manual page 33

OBJ_BUCH-1433-005.book Page 33 Tuesday, August 19, 2014 11:25 AM
Note: The power tool cannot be used during the charge procedure; it is
not defective when inoperative during the charging procedure.
During the charging procedure, the handle of the machine warms up. This
is normal.
Disconnect the battery charger from the mains supply when not using it
for longer periods.
 Protect the battery charger against moisture!
Observe the notes for disposal.
Loading the Magazine (see figure B)
 Use only original Bosch accessories. The precision parts of the pow-
er tool, such as the magazine, the striker and the shot duct, are
matched to Bosch staples. Other manufacturers use other steel quali-
ties and sizes.
– Turn the power tool around.
– Press release buttons 6 and pull out the magazine 10 toward the rear.
– Insert the staple strip 9 with the staple tips pointing upwards.
– Insert the magazine 10 again until it engages.
 Do not exert any force when opening, loading and inserting the
magazine.
Operation
Starting Operation
Switching On and Off
– Firmly place the tacker head 1 against the workpiece first ,until it is
pushed in a few millimetres.
Keep up the contact pressure and briefly press the trigger 5.
Once the staple has been completely driven in, release the trigger 5
and lift the tacker head 1 from the workpiece.
The trigger lock, which is connected with the movable tacker head 1, pre-
vents unintentional shot actuation when the trigger 5 is inadvertently
pressed.
Bosch Power Tools
English | 33
1 609 92A 0PU | (19.8.14)