Table of Contents
Advertisement
Installation
5.1
Securing with clamps
Area of validity
Applies to the central and decentralized designs: Skip this step if you have selected
"installing with screws."
Requirement
• The recessed mounting cut-out has been completed.
• Clamp from the options. Clamp and grub screws are included in the contents of delivery.
Figure 5-1
Procedure
1. Please follow the installation guidelines.
2. Insert the device or the control unit in the decentralized design into the recessed
3. Secure the control unit in the recessed mounting cut-out from behind with the clamp, as
4. Applies only to the decentralized design: Mount the computer unit at at its planned
Panel PC 670 V2/870 V2, Control unit
Operating Instructions, Edition 03/2004, CD Documentation and Drivers
Clamp assembly
mounting cut-out from the front.
shown in the installation cut-out in the dimension diagrams. Tighten the grub screw to a
torque of 0.4-0.5 Nm.
installation location. For additional information, please refer to computer unit operating
instructions.
5
5-1
Advertisement
Table of Contents
