Controller Installation - Toro 53805 Installation & Programming Manual

Controller Installation

For safe, reliable operation, select an installation site which is:
• Weather protected.
• Within 4 ft. (1.2 m) from a grounded 110 VAC, 60 Hz outlet which is not controlled by
a light switch or utilized by a high current load appliance, such as a refrigerator,
air conditioner or garage door opener.
• Accessible to the sprinkler control valve wiring and optional accessory wiring.
Step 1 – Use the Screw Location Template on the back page to mark the screw locations.
Use a level to align the two screws horizontally. Install two screws, 5 inches
(12.7 cm) apart, into the wall at eye level. Leave the screw extended approximately
1/4 inch (6 mm) from the wall to accommodate the controller case.
Step 2 – Hang the cabinet using the back panel's keyhole slot. Make sure the cabinet slides
down securely onto the screws.
Step 3 – (Optional) Remove the controller's access panel and install a center mounting screw.
Tighten securely.
5'' (12.7cm)

Downloaded from www.Manualslib.com
If installing into drywall or masonry, install proper screw anchors.
manuals search engine
lawn
master
SENSOR
ON
OFF
PRG
RS1 RS2 AC1 AC2 COM MV S1 S2 S3 S4 S5 S6
(Optional)
Questions?
Call the Toro Helpline
(800) 367-8676
www.toro.com