Table 20 Service Messages - GE CS5500 Programming Manual

Message Definition
Expansion The expansion module has detected an
Over-Current
excessive amount of current being drawn
from one of its outputs and has disabled
the output as a means of protection.
Expansion The mains power supply is not connected
Power Trouble to an expansion module power supply.
Expansion The connection to an expansion module's
Siren Trouble siren is broken.
Expansion An expansion module or keypad is not
Trouble reporting to the control panel.
Zone Problem, There is a problem with a zone or zones.
Press OK Press OK to identify the zone(s) and the
problem condition.
One of the following messages is
displayed when you press OK.
CleanMe
Lost
Low Battery
Short Loss
Tamper
Trouble
A specific smoke detector
(for example, DP721) is
dirty. The panel detects a
degree of pollution in the
chamber of the fire/smoke
detectors.
The system has not
received RF sensor
transmissions for a long
period of time. Depending
on how the system is
programmed, this
condition activates a
service report. In addition,
it may activate a tamper
alarm if armed.
An RF sensor battery is
low.
The system has not
received RF sensor
transmissions for a short
period of time. This
condition prevents arming.
There is a problem with
the wiring.
There is a problem with
the wiring.

Table 20 Service messages

Action
Check the module for wiring faults.
Reconnect the mains power supply and
ensure it is working properly.
Repair the open circuit.
Ensure that the module is connected
properly to the control panel.
Clean the detection chamber of the smoke
detector.
Ensure that the wireless zone module is
receiving power and has not been tampered
with. Repair any faults.
Replace the battery.
Ensure that the wireless zone module is
receiving power and has not been tampered
with. Repair any faults.
Check the zone and zone sensors for
damage and repair any faults.
Check the zone and zone sensors for
damage and repair any faults.