Motorola PMLN6716 User Manual page 23

Installing Mobile Microphone Gateway to a
Mobile Radio
Carefully select the installation location for the Mobile Microphone
Gateway. Plan the installation so that the location is within convenient
reach of the user, but will not interfere with the operation of the vehicle.
Also, consider the operation of other vehicle accessories.
Functions assigned to the hook switch on the Mobile
Radio are not supported with the Long Ranges Wireless
Solution. Therefore, the hook switch functions must be set
to disabled on the Mobile Radio.
Mounting the Hang-Up Clip
Once an installation location has been decided, perform the following
steps:
Procedure:
1
Verify that the selected mounting surface is strong enough to
support the mounting hardware and the Mobile Microphone
Gateway.
2
Use the base of the hang-up clip as a template to center punch and
drill two three millimeter (0.125 inch) diameter holes. Be careful not
to damage any wires or any other vehicle components when drilling
the holes.
3
Use the two self tapping screws provided to mount and secure the
hang-up clip.
1
Back-up Plate
Figure 3.1: Installing the Mounting Bracket
Making Final Connections
When the hang-up clip is installed and secured, follow the steps below:
Procedure:
1
Snap the Mobile Microphone Gateway into the hang-up clip.
2
Connect the coiled cord plug of the Mobile Microphone Gateway to
the connector on the front of the radio. Align the connector pins then
twist outer collar clockwise to lock in place.
Vehicle
2
Dashboard
Hang-up
3
Clip
Flat-Head
4
Screw
Hex-Washer
5
Head Screw
17
English