Table of Contents
Advertisement
USE OF THE PROGRAMMER
The machine is equipped with a removable
programmer allowing you to modify the
automatic working programs contained in the
memory of the machine.
Every automatic working program could include
specific values of the following working
parameters:
- machine running speed
- pressure of brushes
- intensity of the cleaning solution flow
- uso (yes/no) of the ECO mode
- uso (yes/no) of the brushes
- uso (yes/no) of the suction motor
Note: in order to get a regular solution flow to the
brushes you are obliged to use the
solution pump.
The machine operator can define up to 4
different automatic working programs (named
P1, P2, P3 and P4) depending on the different
applications and working conditions.
When the working programs have been defined
and the machine turned Off the programmer can
be removed. Then it will be possible to select
every one of the set working programs by means
of the buttons P1, P2, P3 and P4 available on the
control panel.
Note: in order to set a new working program the
machine must be in working condition (i.e.
no alert or fluid level signal must be
enabled).
PROGRAMMING THE MACHINE:
EXAMPLES
Program P1: medium intensity scrubbing with
suction enabled.
After having turned the machine Off insert the
removable programmer into the connector of the
control panel.
Turn the machine On. The display will show four
zeros for a few seconds; then the battery voltage
will appear.
24
S31EUK4090SY(2)99-01
Advertisement
Table of Contents
