Table of Contents
Advertisement
Canopy T1/E1 Multiplexer
WARNING!
Substitution of the power supply may impair intrinsic safety. The
Canopy T1/E1 Multiplexer must be used with Model Number TR10R033
manufactured by Cincon Electronics Co., Ltd.
2.2 INSTALLATION PROCEDURES
2.2.1
Package Contents
Verify the contents shipped against the packing list for the box. You should have received
the following:
◦
T1/E1 unit
◦
AC Power supply (Option 1 only)
◦
CD ROM (EMS GUI and the software download application)
2.2.2
Preparing for Installation and Setup
Select the appropriate type of cable for connection to the Ethernet port of the Canopy
T1/E1 Multiplexer as follows:
◦
For connection to a LAN or a switch, a straight-through cable is required.
◦
For connection to the NIC card in a PC, a crossover cable is required.
◦
For connection to a PBX, a T1/E1 crossover cable is likely required. Refer to your
PBX installation instruction manual for specific requirements.
2.2.3
Mounting the Canopy T1/E1 Multiplexer
Mounting option for the unit is either a desk mount or a rack mount. Follow this procedure
to affix the until to a rack mount:
Procedure 1: Affixing the Multiplexer to a rack mount
Remove the Front Panel by removing Front Panel Mounting Screws.
1. Remove the two screw posts from the DB-9 connector.
2. Remove Front Bezel and set aside.
Issue 3
Page 28 of 73
T1/E1 Multiplexer FPGA Version 3.4
September 2004
Advertisement
Table of Contents
