Esp® Hydraulic Unit / Control Module Assembly On-Vehicle Inspection - Suzuki Swift Sport 2004 Service & Repair Manual

Sensor Calibration (Using SUZUKI Scan Tool)
1) Set steering wheel in straight-ahead position.
2) Connect SUZUKI scan tool to data link connector
(DLC) (1) with ignition switch OFF.
Special tool
(A): SUZUKI scan tool
(A)
3) Turn ignition switch to ON position and confirm that
only any of DTC(s) C1075, C1076 and/or C1077 is
detected. If any other DTC are detected, repair the
detected DTC.
4) Park and level the vehicle with parking brake, stop
engine with ignition switch ON, set steering in
straight and without stepping on the brake pedal.
NOTE
Hold the above condition in Step 4) to
calibrate sensor correctly until sensor
calibration is completed.
5) Select menu "SENSOR CALIBRATION" under
"MISC. TEST" mode of SUZUKI scan tool and
calibrate sensor. Refer to scan tool operator's
manual for further derails.
6) After completing the calibration, turn ignition switch
to OFF position and disconnect SUZUKI scan tool
from DLC.
Steering Angle Sensor Calibration (Not Using
SUZUKI Scan Tool)
1) Set steering wheel in straight-ahead position.
2) Connect battery terminals and/or fuse and start
1
I4RS0B450003-01
3) Drive vehicle straight on level ground at 15 km/h (9.5
ESP® Hydraulic Unit / Control Module
Assembly On-Vehicle Inspection
Check hydraulic unit for fluid leakage.
If any, repair or replace.
Electronic Stability Program:
engine.
NOTE
When power is not supplied to the steering
angle sensor by removing battery or fuse,
DTC C1075 is detected and SLIP indicator
lamp (1) flashes.
If DTC other than C1075 is detected, SLIP
indicator lamp flushes and other indicator
illuminate. In that case, repair the detected
DTC first.
mph) or above for few seconds without spinning
wheels. And confirm that SLIP indicator lamp is OFF.
CAUTION
!
Never disassemble ESP® hydraulic unit /
control module assembly, loosen blind plug
or remove motor. Performing any of these
prohibited services will affect original
performance of ESP® hydraulic unit / control
module assembly.
4F-55
1
I6RS0B460028-02
S7RS0B4606027