1C-1 Engine Electrical Devices:
Engine Electrical Devices
Engine
Engine Control Module (ECM) Removal and
Installation
CAUTION
!
As ECM consists of precision parts, be
careful not to expose it to excessive shock.
NOTE
For vehicle equipped with immobilizer
control system:
If ECM is replaced with new one or with
another one, make sure to register
immobilizer transponder code to ECM
correctly according to "Procedure after ECM
Replacement in Section 10C".
Removal
1) Disconnect negative cable at battery.
2) Remove ECM cover.
3) Disconnect connectors from ECM as follows.
a) Push lock (1) to release locking of lock lever (2).
b) Turn lock lever to arrow direction until it stops.
1
4) Remove ECM (1) from its bracket by removing its
mounting bolts (2).
2
Repair Instructions
S6RW0C1306001
2
I4RS0A130003-01
1
2
I5RW0A130001-01
Installation
Reverse removal procedure noting the following:
• Connect connectors to ECM as follows.
a. Make sure that lock lever of ECM connector is
unlock position.
b. Insert ECM connectors to ECM until it stops with
unlocked lock lever.
c. Lock ECM connectors securely by pulling its lock
lever up.
I4RS0B130021-01
I4RS0B130022-01
I4RS0A130004-01