Mil Remains On After Engine Starts - Suzuki 2006 SX4 Service Manual

MIL Remains ON after Engine Starts

Wiring Diagram
Refer to "MIL Does Not Come ON with Ignition Switch ON and Engine Stop (but Engine Can Be Started)".
Circuit Description
When the ignition switch is turned ON, ECM causes the main relay to turn ON (close the contact point). Then, ECM
being supplied with the main power, transmits indication ON signal of MIL to combination meter in order to turn MIL
ON. And then, combination meter turns MIL ON. When the engine starts to run and no malfunction is detected in the
system, ECM transmits MIL indication OFF signal to combination meter in order to turn MIL OFF. And then,
combination meter turns MIL OFF, but if a malfunction was or is detected, MIL remains ON even when the engine is
running.
Troubleshooting
NOTE
When measuring circuit voltage, resistance and/or pulse signal at ECM connector, connect the special
tool to ECM and/or the ECM connectors referring to "Inspection of ECM and Its Circuits".
Step
1 DTC check
1) Start engine and recheck DTC of ECM and TCM while
engine running.
Is there any DTC(s)?
2 CAN communication line circuit check
1) Check CAN communication line circuit between control
modules for open, short, high resistance and
connections referring to Step 5 to 10 under
"Troubleshooting for Communication Error with Scan
Tool Using CAN".
Is circuit in good condition?
Action
Engine General Information and Diagnosis:
Yes
Go to Step 2 of "Engine
and Emission Control
System Check", Step 2
of "A/T System Check in
Section 5A".
Substitute a known-
good combination meter
and recheck. If MIL still
remains ON, substitute
a known-good ECM and
recheck.
1A-57
S6RW0C1104013
No
Go to Step 2.
Repair or replace CAN
communication circuit.