Dip Switch Functions - Toshiba e-STUDIO230L Service Handbook

3.12.7

DIP switch functions

You can simulate various functions by setting the DIP switch (SW1) on the finisher controller PC board
appropriately.
Initiating Operations
1) Remove any obstacles from the area of operation.
2) Set the DIP switch (SW1) as shown, and turn ON the power (so that LED1 will start to blink).
3) Press the pushing switch (SW2) twice to initiate the operation in question. (LED2 will remain on dur-
ing operation).
Setting
Delivery motor
ON
1 2 3 4 5 6 7 8
Stack processing
motor (stack deliv-
ON
ery lever)
1 2 3 4 5 6 7 8
Stack processing
motor (returning
ON
roller)
1 2 3 4 5 6 7 8
Front jogging plate
motor
ON
1 2 3 4 5 6 7 8
Rear jogging plate
motor
ON
1 2 3 4 5 6 7 8
Upper stack tray
motor (up)
ON
1 2 3 4 5 6 7 8
Upper stack tray
motor (down)
ON
1 2 3 4 5 6 7 8
Lower stack tray
motor (up)
ON
1 2 3 4 5 6 7 8
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Item Operation
The delivery roller rotates in a spe-
cific speed.
The stack delivery lever moves to its
home position and stops.
The returning roller moves to the
home position and stops.
When not at the
home position
When at the
home position
When not at the
home position
When at the
home position
The upper stack tray moves up and
stops when the upper stack tray
upper limit sensor turns ON.
The upper stack tray moves down
and stops when the lower stack tray
lower limit sensor turns ON.
The lower stack tray moves up and
stops when the lower stack tray
upper limit sensor is turned ON.
3 - 93
• Press SW2 again.
• Turn OFF the joint
sensor (S4).
• Turn OFF the joint
sensor (S4).
• Turn OFF the joint
sensor (S4).
The front jogging • Turn OFF the joint
plate moves to its sensor (S4).
home position and
stops.
The front jogging • Turn OFF the joint
plate moves over a sensor (S4).
specific position
and stops at the
home position.
The rear jogging • Turn OFF the joint
plate moves to the sensor (S4).
home position and
stops.
The rear jogging • Turn OFF the joint
plate moves over a sensor (S4).
specific distance
and stops.
• Press SW2 again.
• Turn OFF the joint
sensor (S4).
• Press SW2 again.
• Turn OFF the joint
sensor (S4).
• Press SW2 again.
• Turn OFF the joint
sensor (S4).
e-STUDIO200L/202L/203L/230/232/233/280/282/283
To stop
ADJUSTMENT
3