Initial Setup - Motorola MOTORAZR maxx V6 Developer's Manual

Java ME Developer Guide
Chapter 15 - JSR-205 - WMA 2.0
15.1.9 MMS Push
The registration for MMS-push mechanism and MMS-push mechanism itself shall be
implemented, but applied to MMS messages in addition to what is described in the
MIDP 2.0 chapter. This includes push registry and all user dialogues.
When an application that is registered in the Push Registry is deleted, the corres-
ponding PUSH entry shall be deleted and the corresponding application ID shall be
made available for future PUSH registrations.
15.2 Requirements for WMA
The WMA shall accept the application-ID allocated by the first application. If other
applications try to allocate the same application-ID while it is being used by the first
application, an IOException shall be thrown when they attempt to open the Message-
Connection. The same rule applies if an application-ID is being used by a system ap-
plication in the device. In this case, the Java application will not be able to use that
application-ID.
MMS-push mechanism shall be implemented as described in the MIDP 2.0 chapter
and some specific requirements are defined below in this section.

15.2.1 Initial Setup

The MMS initial setup parameters set by user shall not be accessible by WMA. The
initial MMS setup requirements are outside the scope of this document.
The Java Client will use the MMS Setup of the native client to send/receive mes-
sages. So the Java client will use the same APN/Web-Sessions/mmsc etc. as the
Native Client.
15.2.2 Handling the incoming MMS message
DRAFT - Subject to Change
[118/201]