Motorola 2200 Administrator's Handbook page 174

Administrator's Handbook
To add a filter, click the
1.
The Input Rule Entry page appears.
If you want the filter to forward packets that match its criteria to the destination IP
2.
address, check the
If Forward is unchecked, packets matching the filter's criteria will be discarded.
Enter the Source IP
3.
You can enter a subnet or a host address.
Enter the Source Mask
4.
This allows you to further modify the way the filter will match on the source address. Enter 0.0.0.0 to
force the filter to match on all source IP addresses, or enter 255.255.255.255 to match the source IP
address exclusively.
Destination IP
Enter the
5.
You can enter a subnet or a host address.
Destination Mask
Enter the
6.
This allows you to further modify the way the filter will match on the destination address. Enter 0.0.0.0
to force the filter to match on all destination IP addresses.
If desired, you can enter a TOS and TOS Mask value.
7.
See "Policy-based Routing using Filtersets" on page 177
Protocol
Select from the pull-down menu: ICMP, TCP, UDP, Any, or the number of
8.
another IP transport protocol (see the table on
If Protocol Type is set to TCP or UDP, the settings for port comparison will appear. These settings only
take effect if the Protocol Type is TCP or UDP.
Source Port Compare
From the
9.
filter to use on a packet's source port number.
Source Port
Then select
page 166).
From the Destination Port Compare pull-down menu, choose a comparison method for
10.
the filter to use on a packet's destination port number.
Destination Port
Then select
on page 166).
174
Add button under Input Rules.
Forward
checkbox.
address this filter will match on.
for the source IP address.
Address this filter will match on.
for the destination IP address.
pull-down menu, choose a comparison method for the
and enter the actual source port number to match on (see the table on
and enter the actual destination port number to match on (see the table
for more information.
page 167).