Toshiba e-STUDIO200L Service Manual page 81

[D-2] e-STUDIO202L/203L/232/233/232S/282/283/282S/283S
(1) Take off the SYS board cover (
Hard disk (HDD)").
(2) Disconnect 4 connectors and release the
harness from 1 harness clamp.
(3) Remove 5 screws and take off the SYS
board case.
[E] Logic PC board (LGC board)
(1) Take off the rear cover
( P.2-31 "[C] Rear cover").
(2) Loosen 4 screws and take off the bridge
bracket.
Note:
The LGC boards of e-STUDIO200L/230/
230L/280/280S and e-STUDIO202L/203L/
232/233/232S/282/283/282S/283S are differ-
ent in appearance.
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
P.2-41 "[A]
SYS board case
e-STUDIO200L/202L/203L/230/232/233/280/282/283
2 - 47
07/11
Fig. 2-59
Fig. 2-60
Bridge bracket
Fig. 2-61
OUTLINE OF THE MACHINE
2