Bypass Feed Copying; Interruption Copying - Toshiba e-STUDIO200L Service Manual

4.2.4

Bypass feed copying

1) Insert a sheet of paper into the bypass tray.
→ Bypass paper sensor ON
- "Ready for bypass feeding" is displayed.
2) Press the [START] button
→ "Ready for bypass feeding" changes to "COPYING"
→ Exposure lamp ON
→ Scan motor ON
Carriages -1 and -2 move forward
→ Polygonal motor rotates in high speed
→ Main motor and exit motor ON
- The drum, fuser unit, developer unit and exit roller are driven.
3) Bypass feeding
→ Main charger, developer bias and discharge LED ON. Fans are rotated in high speed.
→ Bypass feed clutch ON
- The bypass pickup roller start to rotate.
- The bypass pickup roller is lowered.
- The bypass feed roller start to rotate.
→ Aligning operation
→ Paper reaches the registration roller
→ After a certain period of time, the bypass feed clutch OFF
4) Hereafter, the operation 3) through 6) of
feeding)" is repeated.
4.2.5

Interruption copying

1) Press the [INTERRUPT] button
→ LED "INTERRUPT" ON
→ Copying operation in progress is temporarily stopped. Carriages -1 and -2 return to appropriate
positions.
→ "Job interrupted job 1 saved" is displayed.
→ Automatic density and reproduction ratio 100% are set (The set number remains the same)
2) Select the desired copy condition
3) After the interruption copying is finished:
→ LED "INTERRUPT" OFF by pressing the [INTERRUPT] button
→ Equipment returns to the status before the interruption
→ "Ready to resume job 1" is displayed
4) Press the [START] button
→ The copying operation before the interruption is resumed.
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
P.4-3 "4.2.3 Drawer feed copying (Upper drawer paper
e-STUDIO200L/202L/203L/230/232/233/280/282/283
4 - 5
GENERAL OPERATION
4