D-Link DSN-1100 X Stack User Manual page 50

8. By default, all iSCSI initiators will have access to the volume you create. If you
prefer, you can grant access to one or more iSCSI initiators listed in the screen,
grant access to an initiator not in the list, or not grant access to an initiator at this
time. If you decide to select multiple iSCSI initiators from the list, you can use the
following shortcuts:
For adjacent iSCSI initiators, click the first one, then hold down the Shift key
–
and click the last one. The first and last initiators, and all the initiators
between them, get selected.
For non-adjacent initiators, click the first one, then hold down the Ctrl key and
–
click each subsequent initiator.
To deselect an initiator, hold down the Ctrl key and click an initiator that is
–
selected.
9. Click Next.
The Ready to Create Volume screen appears (see Figure 3-19).
10. If you are satisfied with your selections click Finish to create the volume.
Otherwise, click the Back button to return to the screen where you need to change
a selection. Then click Next until you return to this screen and click Finish to
create the volume.
If the volume is created, a message similar to the one in Figure 3-20 appears.
40 Chapter 3 Managing Volumes
If you decide not to grant access to an initiator now, you can do so at a later
time (see section 3.3).
Figure 3-19. Ready to Create Volume Screen