For adjacent disks, click the first one, then hold down the Shift key and click
–
the last one. The first and last disks, and all the disks between them, get
selected.
For non-adjacent disks, click the first one, then hold down the Ctrl key and
–
click each subsequent disk.
To deselect a disk, hold down the Ctrl key and click a disk that is selected.
–
6. Click Next.
If you selected Stripe/Mirror, Parity, or Stripe, a Stripe Depth screen similar to
the one in Figure 3-16 appears and you should proceed to the next step. Otherwise,
the Volume Size screen appears (see Figure 3-17) and you should skip to step 8.
7. By default, the Wizard will select the stripe depth (chunk size) for volumes
configured as stripe/mirror, parity, or stripe. If you prefer, use the Stripe Depth
drop-down list to select from one of the commonly used chunk sizes. Click Next.
The Volume Size screen appears (see Figure 3-17).
38
Chapter 3 Managing Volumes
Figure 3-16. Stripe Depth Screen