ABB ACS350 User Manual page 52

52
After completing a set-up task, the Start-up Assistant suggests the
next one.
OK
• Press
suggested task.
• Press key
the following task without doing the suggested task.
• Press EXIT
The start-up is now completed. However, it might be useful at this
stage to set the parameters required by your application and save
the settings as a user macro as instructed in section
on page 94.
After the whole set-up is completed, check there are no faults or
alarms shown on the display and the panel LED is green and does
not blink.
Start-up, control with I/O and ID Run
(when is highlighted) to continue with the
Continue
to highlight
Skip
to stop the Start-up Assistant.
SAVING A USER MACRO AND FINAL CHECK
The drive is now ready for use.
OK
and then press
User macros
REM CHOICE
Do you want to
continue with
application setup?
Continue
Skip
EXIT
to move to
00:00 OK