Fasten Clamping Plates; Attach The Optional Fieldbus Module - ABB ACS350 User Manual

28

Fasten clamping plates

See Figure a below.
1. Fasten the clamping plate to the plate at the bottom of the drive with the provided
screws.
2. Fasten the I/O clamping plate to the clamping plate (frame sizes R0...R2) with the
provided screws.
a

Attach the optional fieldbus module

See Figure b above.
3. Connect the power and control cables as instructed in chapter
installation.
4. Place the fieldbus module on the option ground plate and tighten the grounding
screw on the left corner of the fieldbus module. This fastens the module to the
option ground plate.
5. If the terminal cover is not already removed, push the recess in the cover and
simultaneously slide the cover off the frame.
6. Snap the fieldbus module attached to the option ground plate in position so that
the module is plugged to the connection on the drive front and the screw holes in
the option ground plate and the I/O clamping plate are aligned.
7. Fasten the option ground plate to the I/O clamping plate with the provided screws.
8. Slide the terminal cover back in place.
Mechanical installation
1
2
1
b
2
5
8
4
6
7
4
7
3
3
Electrical