Changing The Dehumidification Mode; Discharging The Residual Water In The Drain Hose During The Auto Self Clean Operation - Hitachi BD-S5500 Operating Instructions Manual

Table of Contents

Other Settings

You can change the method of dehumidification used during drying operations.

Air Cooling Mode: Expels moisture and warm air from the drain hose during drying operations.

Water Cooling Mode: Uses water for dehumidification during drying operations. (More water is consumed.)

You cannot set the dehumidification mode to Water Cooling Mode when the [POWER SAVE] or

[POWER SAVE STATIC DRY] program is set. Similarly, you cannot select the [POWER SAVE] or

[POWER SAVE STATIC DRY] program when Water Cooling Mode is set.

Press <ON> to turn on the power.

Hold <DRY> for at least 3 seconds.

Press <OFF> to turn off the power.

This setting will be saved.

Water Cooling Mode is always used during the [SILENT], [FUZZY (15 MIN)], and [DEODORANT] programs, and

the <STEAM IRON> operation.

Discharging the residual water in the drain hose

during the AUTO SELF CLEAN operation

Residual water in the drain hose is discharged by passing air through the drain hose during the

<AUTO SELF CLEAN> operation.

Press <ON> to turn on the power.

Hold <SPIN> for at least 3 seconds.

Press <OFF> to turn off the power.

This setting will be saved.

To change the setting, perform the same operation.

(continued)