Canon Finisher-AB1 Service Manual page 356

Chapter 5
2. Adjusting the Horizontal Registration
1) Disconnect the finisher from the host machine.
2) Loosen the 2 screws [2] on the positioning plate
[1] found on the right side.
3) If the value recorded is on the + side, move the
plate in the direction of [A] and tighten the screw
[2].
If the value recorded is on the - side, on the other
hand, move the plate in the direction of [B] and
tighten the screw [2].
[2]
[B]
F-5-16
3. Adjusting the Angle
If the angle is as indicated, start with step 7).
1) Lift the upper cover [1], and detach the inside
cover (upper) [2].
- 1 knob [3]
- 8 screws [4]
5-8
[1]
[A]
[3]
[2]
F-5-17
2) Loosen the 2 screws [2] on the latch base (front)
[1].
3) If the value recorded is on the + side, move the
base in the direction of [A] and tighten the screw
[2].
If the value recorded is on the - side, on the other
hand, move the base in the direction of [B] and
tighten the screw [2].
Make sure that the total of the indexes over which the
latch base (front, rear) is moved is between -2 and +2
mm.
[4] [1]
[4]