Appendix B Frus And Compatibility Matrixes; Mpus; Lpus - HP 10504 Installation Manual

Appendix B FRUs and compatibility matrixes

This appendix describes the FRUs available for the switch and their compatibility.
All the FRUs listed in this appendix are hot swappable.

MPUs

CAUTION:
Use the Comware V5 software (with the version number R1XXX) for the LSU1SUPA0. Use the Comware
V7 software (with the version number R2XXX) for the LSU1SUPB0.
MPU is the supervisor engine and core of the control management plane for the switch. The switch
supports the MPUs LSU1SUPA0 and LSU1SUPB0. They are applicable to all 10500 switch models.
MPUs are ordered separately. The switch requires one MPU to operate correctly. You can also install two
MPUs of the same model for redundancy.
Table 20 describes the MPU specifications, and
matrix.
Table 20 MPU specifications
Item
Interfaces
Interface transmission
rate
Cables and max
transmission distance
Table 21 MPU product code and model matrix
MPU model
LSU1SUPA0
LSU1SUPB0

LPUs

The LPUs in
descriptions. For more information about the transceiver modules that each LPU supports, see
"Transceiver
Description
•
One console port for local or remote dialup configuration management
•
One 10/100/1000BASE-T interface for management and upgrade
•
Console port—No greater than 1 15200 bps and defaults to 9600 bps
•
10/100/1000BASE-T interface—10/100/1000 Mbps
•
Console port—15 m (49.21 ft) over common asynchronous serial interface cable
•
10/100/1000BASE-T interface—100 m (328.08 ft) over Category-5 twisted
pairs
Product code
JC614A
JG375A
JG496A
Table 22 are compatible with all 10500 switches.
modules."
Table 21
HP description
HP 10500 Main Processing Unit
HP 10500 TAA-compliant Main Processing Unit
HP 10500 Type A Main Processing Unit with Comware V7 Operating
System
66
shows the MPU product code and model
Table 23 lists their product codes and