HP 10504 Installation Manual page 102

Figure 56 Binding cables where they must be bent
Route, bind, and attach excess cables for easy and safe maintenance and correct operation.
•
Do not tie power cords to slide rails.
•
When you connect a cable to an articulated part, such as connecting a grounding cable to a
•
cabinet door, leave enough slack in cables and make sure they are not stressed from any movement
of the part.
Cables must be protected at points where they might rub or come in contact with sharp edges or
•
heated areas. Use high temperature cables near heat sources.
Securely fasten cables and take adequate measures to prevent loose connections.
•
Figure 57 Securely fastening cables
(1) (1)(2) (1) (1)(2)
(1) Flat washer
Fasten heavy or rigid power cords at the connectors to relief stress.
•
Do not use tapping screws to fasten the connecting terminals.
•
Bind together cables that are the same type and routed in the same direction.
•
Figure 55 lists the cable bundling specifications.
Table 58 Tie-binding parameters
Cable bundle diameter (mm)
10
10 to 30
(3) (3)
(2) Spring washer
Space between bundles (mm)
80 to 150
150 to 200
96
(3) Nut