Correcting Horizontal Mitre Angles - Festool KAPEX KS 120 Instruction Manual

18
Laser beam is not visible
First check whether the laser is switched on. If not,
press the button (2.1) to switch on the laser.
Identify which laser beam is not visible.
– Turn the adjusting screws for the left (22.2) and
right (22.4) laser until the laser beam shines on
the workpiece.
– As described, fi rst (a) adjust the laser beam so
it is parallel with the scribe line, then (b) adjust
the inclination angle and fi nally (c) adjust the
axial displacement of the laser beam.
a) Laser beam is not parallel with the scribe line
[Fig. 22A]
Adjust until parallel.
22A
Left laser beam
Right laser beam
b) Laser beam strays off line when workpiece
trimmed towards the left or right [Fig. 22B]
Adjust the inclination angle until the laser beam
no longer strays off line when workpieces are
trimmed.
Left laser beam
Right laser beam
Adjusting screw (22.3)
Adjusting screw (22.5)
Adjusting screw (22.2)
Adjusting screw (22.4)
22B
c) Laser beam is not positioned on the cut
[Fig. 3C]
Adjust the axial displacement.
22C
Left laser beam
Right laser beam

Correcting horizontal mitre angles

If the pointer (23.2) no longer rests on the preset
mitre angle values, you can loosen the screw (23.1)
and readjust the pointer.
Adjusting screw (22.1)
Adjusting screw (22.6)
23.1
23.2
23.3