Child Lock - Panasonic ECONAVI NA-FS95G3WAU Operating Instructions Manual

Accessories
1 Water supply hose for COLD
(Grey)
1 Water supply hose for HOT
(White)
1 Bottom cover
(Anti-vermin cover)
(This cover is attached to the back
of the washing machine at the time
of purchase.)
2 Levelling rubber
pads
Water Temperature Settings (P.11)
Press the [Temp Setting] button
repeatedly until the lamp on the left of
the desired water temperature lights up.
ECONAVI (P.14)
Start/Pause Power Switch
Press to start. Turns on/off the washing machine.
●
Press to pause
during a cycle.
●
Press again to
restart.

Child Lock

This is an emergency alarming mode to prevent a child
from drowning by falling into the tub filled with water.
If you open the lid when the washing machine is running
and the tub is filled with water, the washing machine will
pause and you will hear warning beeps. When this
happens, check immediately if there is any problem. If
you leave the lid open for more than 10 seconds, "U99"
(P.26) will appear, the Child Lock lamp will flash, and the
water will be drained.
■ How to set/cancel the mode
Before you begin
●
Close the lid.
You cannot set or cancel the Child Lock when the lid is
open.
●
Turn on the washing machine.
Hold down the [Program] button for more than
5 seconds.
When the Child Lock is set, you will hear two short beeps
and the Child Lock lamp will light up.
When the Child Lock is cancelled, you will hear two short
beeps twice and the Child Lock lamp will turn off.
Note
When Child Lock is being set, "CL" is shown for 2 seconds in
the display area each time you turn on the washing machine.
About the display area
Air Dry (hours)
Reserve (hours)
Time Left (min)
L
Note
●
Any time exceeding 99 minutes is displayed as "--".
The washing machine turns off automatically at the
end of a cycle.
It turns off automatically if you do not start a cycle
within 10 minutes after turning it on.
The drying time is displayed when you
press the [Air Dry] button. (P.19)
The finishing time of a cycle is displayed
when you press the [Timer Delay] button.
(P.11)
The remaining time is displayed during a
cycle.
The water level (P.20) is displayed when
a cycle starts.
5