Nokia 2608 Service Manual
Hide thumbs Also See for 2608:

Advertisement

Page 1 (21)
SERVICE MANUAL
Level 1&2
Confidential
Copyright © 2008 NOKIA. All rights reserved.
2608
RM-376
Transceiver characteristics:
Band:
CDMA: 800MHz, IS95, CDMA2000 1xRTT
Display:
Main LCD: 1.8"/128x160 pixel; 262K colors
Second LCD: N/A
Camera:
N/A
Operating System:
Real-Time Executive (REX) operating system
Connections:
Wireless: N/A
Connector: Micro USB Connector
Memory:
No external memory
Transceiver with BL-5BT 870mAh Li-ion battery pack
Talk time
Standby
At least 210
At least 240
minutes
hours
2608 RM-376
Service Manual Level 1&2
Note
Depends on network
parameters and
phone settings
Issue 1

Advertisement

Table of Contents
loading

Summary of Contents for Nokia 2608

  • Page 1 No external memory Transceiver with BL-5BT 870mAh Li-ion battery pack Talk time Standby Note At least 210 At least 240 Depends on network minutes hours parameters and phone settings Page 1 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.
  • Page 2: Table Of Contents

    CARE AND MAINTENANCE...................... 5 BATTERY INFORMATION......................5 EXPLODED VIEW........................6 LEVEL 2 SOLDER COMPONENTS..................7 SERVICE DEVICES........................7 SW-UPDATE ..........................8 DISASSEMBLY INSTRUCTION ....................9 ASSEMBLY INSTRUCTION ....................16 Page 2 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.
  • Page 3: Change History

    Approved version The purpose of this document is to help NOKIA service levels 1 and 2 workshop technicians to carry out service to NOKIA products. This Service Manual is to be used only by authorized NOKIA service suppliers, and the content of it is confidential.
  • Page 4: Warnings And Cautions

    5. Ensure all cables and wires are repositioned correctly. 4. ESD PROTECTION Nokia requires that service points have sufficient ESD protection (against static electricity) when servicing the phone. Any product of which the covers are removed must be handled with ESD protection. The SIM card can be replaced without ESD protection if the product is otherwise ready for use.
  • Page 5: Care And Maintenance

    Batteries’ performance is particularly limited in temperatures well below freezing. Do not dispose batteries in a fire! Dispose of batteries according to local regulations (e.g. recycling). Do not dispose as household waste. Page 5 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.
  • Page 6: Exploded View

    2608 RM-376 Service Manual Level 1&2 7. EXPLODED VIEW 2608 RM-376 EXPLODED VIEW Page 6 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.
  • Page 7: Level 2 Solder Components

    Service Bulletin (SB-011) on NOKIA Online. Supplier or manufacturer contacts for tool re-order can be found in “Recommended service equipment” document on NOKIA Online. Page 7 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.
  • Page 8: Sw-Update

    Flash Concept – (Point of Sales) Please check always for the latest version of flash software, which is available on NOKIA Online. For detailed flashing instruction, please refer to Nokia Care Suite Store version user manual. Page 8 (21) Confidential Issue 1...
  • Page 9: Disassembly Instruction

    2608 RM-376 Service Manual Level 1&2 11. DISASSEMBLY INSTRUCTION 1. Nokia 2608 disassembly. 2. You will need the Nokia Standard Toolkit version 2. Also refer to the General Mechanical Guideline Video for additional hints about the tools and component handling.
  • Page 10 PWB from the C-cover hook 10. Remove the PWB from C-cover. 12. Pull C-cover lip and push Keymat from bottom to top. 11. Use tweezers to clip microphone rubber away. Page 10 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.
  • Page 11 17. Peel off the Main lens film by tweezers. the two screws (T1.6x2.6). When using torque driver, set torque to 10Ncm @ 450 rpm. The tolerance is +/-2Ncm. Page 11 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.
  • Page 12 A-Cover and B-cover. (Top Side). hinge cap hinge cap hinge cap hinge cap 23. There are two hinge caps. 24. Take two hinge caps off. Page 12 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.
  • Page 13 28. Use tweezers to clip Vibrator and pull upward to remove it carefully. remove it carefully. 30. Use tweezers to clip Receiver and pull vertically to 29. Pull upward to remove LCD module away. remove it. Page 13 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.
  • Page 14 B-cover to separate C-cover. 35. Insert a screwdriver/tweezers into the hole on the 36. Remove the RFC from C-cover. B-cover to push hinge out of the B-cover. Page 14 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.
  • Page 15 38. Press the front side of lens to separate the lens from 37. Use tweezers to take out the hinge shaft. B-cover and remove the old adhesive around the B-cover. Page 15 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.
  • Page 16: Assembly Instruction

    2608 RM-376 Service Manual Level 1&2 ASSEMBLY INSTRUCTION 2. You will need the Nokia Standard Toolkit version 2. 1. Nokia 2608 assembly. Also refer to the General Mechanical Guideline Video for additional hints about the tools and component handling. Fig1 Fig1 3.
  • Page 17 9. Take a hinge sponge push into B cover. 10. Take a magnet push into B cover. 11. Insert Receiver into the cavity of B-cover. 12. Insert LCD Module into the B-cover. Page 17 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.
  • Page 18 Put and press it by hand. 17. Put hinge cap into B-cover in the direction as the 18. Take a Flash Light Rubber push into B cover. pictures indicated. Page 18 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.
  • Page 19 23. Use tweezers to clip Headset Jack and put it into 24. Take a keymat and let it assembly in C-cover form Left cavity of D-cover. side Page 19 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.
  • Page 20 (T1.6x2.8) from D-Cover into C-Cover. When using driver, hook of C-Cover and press D-Cover into C-Cover set torque to 10-Ncm @ 700 rpm. The tolerance is +/- peripherally. 2Ncm. Page 20 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.
  • Page 21 2608 RM-376 Service Manual Level 1&2 31. Put Battery downward into the concavity of the 32. Press and slide the Battery Cover onto the D-Cover. D-Cover. Page 21 (21) Confidential Issue 1 Copyright © 2008 NOKIA. All rights reserved.

Table of Contents