connection & installation
To install the light projector
Insert 4 hex screws into the hole in the bottom of the bracket
1.
as shown.
Use 4 hex screws from outside bottom up to fix the light
2.
projector. Insert the hex screw into the center hole from the
top of the mount to the light projector.
Connect the cables.
3.
Insert the projector cables through the rear hole of the
4.
camera.
Connect the wires to the PCB as appropriate.
5.
This is for SCU-2370. The wiring diagram for SCU-VAC/
VAC1/9051 is provided in the separate sub manual.)
connection & installation
22_