QUICK GUIDE TO SOLVING PROBLEMS
Problem
The display doesn't come on &
there is no signal from the
controller
The display is on but there's
no signal
The battery symbol is flashing
The contractions are very weak
even when the intensity is high
Unpleasant feeling beneath
the gel pads
The
The
symbol has appeared on
symbol has appeared on
the display*
E002/E003/E004 has appeared
on the display
* The
* The
symbol always appears in conjunction with the left/right arrows. If the left arrow appears, there
symbol always appears in conjunction with the left/right arrows. If the left arrow appears, there
is a problem with the left gel pad, the right arrow indicates a problem with the right gel pad and if both
arrows appear, there is a problem with either the middle gel pad or all three gel pads.
6
Possible cause
The batteries are inserted
incorrectly
The batteries are dead
Low-quality batteries used
The session has been paused
The batteries are low
The batteries are low
The gel pads are worn
Poor gel pad positioning
Gel pads not covering studs
Low-quality batteries used
The gel pads are worn
Gel pads not covering the studs
Too many consecutive sessions
Gel pads not in contact with skin
Gel pads not covering metal studs
The gel pads are worn
The gel pads are on the wrong
way around
The covers are still on the gel pads
Controller is not fully inserted in
holster
Belt is loose or open on body
Error message, indicating a
problem with the controller
Solution
Reposition the batteries as
described on page 3
Replace the batteries
Use only high-quality batteries
Press the on/off button briefly
Replace the batteries
Replace the batteries
Contact your local stockist for
new
abdominal
SLENDERTONE
replacement gel pads
See page 3 for the correct
positioning of the gel pads & belt
Reposition the gel pads
Use only high-quality batteries
Contact your local stockist for
new
abdominal
SLENDERTONE
replacement gel pads
Reposition the gel pads
You should leave at least six
hours between sessions
Reposition the belt
Reposition the gel pads
Contact your local stockist for
new
abdominal
SLENDERTONE
replacement gel pads
Ensure the black surface of the
gel pads are facing you
Ensure the covers are removed
from both sides of the gel pads
Push the controller into the
holster until it clicks into place
Refasten the belt properly
E002 - switch controller off and
on again. If it persists, return
controller for repair. E003 or E004
indicate an internal fault. Return
controller for repair.
Need help?
Do you have a question about the ABS3 and is the answer not in the manual?