Wiring Diagram; Wiring Diagrams; Wire Color Codes; Wire Digit Codes - SeaDoo GTI Shop Manual

WIRING DIAGRAMS

WIRE COLOR CODES

First color of a wire is the main color. Second color
is the tracer.
Example: YELLOW/BLACK (YL-BK) is a YELLOW
wire with a BLACK tracer.

WIRE DIGIT CODES

First number indicates in which connector the wire
is plugged in.
Second number indicates the position of the wire
in the connector.
The letter at the end of the number (if applicable)
indicates a common circuit in the MPEM printed
circuit with another wire bearing the same letter.
Example: 2-18 (g)
The first number indicates that the wire is posi-
tioned in the connector no. 2 of the MPEM.
The second number indicates that the wire is po-
sitioned in cavity no. 18 of the connector.
The letter (g) indicates a common circuit with an-
other wire(s) bearing the same letter (g) in the cir-
cuit.
ECM
GTX 4-TEC Models
On the ECM, circuits are identified by a letter fol-
lowed by a number.
The letter indicates in which connector the wire is
plugged in.
The number indicates the position of the wire in
the connector.
The connector "A" is connected to the engine
wiring harness.
The connector "B" is connected to the watercraft
wiring harness.

DEUTSCH CONNECTORS

All Models
Deutsch connectors are used to connect wiring
harness to the magneto the electrical box (some
models) and the VCK (DI and 4-TEC models).
smr2004-Complete Line Up
Removal from Engine Connector
Bracket
GTX 4-TEC Models
To remove Deutsch connectors from engine con-
nector bracket, remove the expansion coolant
tank.
1. Expansion coolant tank
2. Tank bracket
Slide a flat screwdriver between the connector
bracket and the Deutsch connectors and remove
connectors.
1. Engine connector bracket
2. Deutsch connectors
www.SeaDooManuals.net
Section 18 WIRING DIAGRAM
Subsection 01 (WIRING DIAGRAMS)
787