Dess Key Programming - SeaDoo GTI Shop Manual

DESS KEY PROGRAMMING

There is two tools available that can be used to
communicate with the MPEM in order to program
a DESS key.
The VCK (Vehicle Communication Kit) (P/N 529
035 981) is the primary tool.
B.U.D.S., included in the VCK, is designed to
allow, among other things, the programming of
safety lanyard(s) and entering customer informa-
tion.
For more information pertaining to the use of the
software B.U.D.S., use its help which contains de-
tailed information on its functions.
WARNING
If the computer you are using is connected
to the 110 Vac power outlet, there is a poten-
tial risk of electrocution when working in con-
tact with water. Be careful not to touch water
while working with the VCK.
The MPEM programmer (P/N 529 035 878) is the
alternative tool to communicate with the MPEM.
For a complete overview of this tool, refer to the
MPEM Programmer Guide.
Programming Keys with B.U.D.S.
Connect VCK components and open the software
B.U.D.S.
1. 6-pin adapter (P/N 529 035 679)
2. DESS adapter (P/N 529 035 684)
smr2004-Complete Line Up
Subsection 05 (DESS (CARBURETED AND RFI ENGINES))
RFI Models
It is also possible to disconnect the connector
shown in the following picture and install the RFI
DESS adapter (P/N 278 001 978).
1. Connector to be disconnected
After all connections are done, connect the safety
lanyard to the DESS post to activate the commu-
nication.
All Models
IMPORTANT: When using the software B.U.D.S.,
ensure that the protocol matching the connec-
tion used is properly selected in "MPI" under
"Choose protocol" as per the following chart.
TYPE OF
CONNECTION
Through DESS
Through
6-pin DESS
connector
(RFI models)
Read MPEM using leftmost icon in B.U.D.S.
www.SeaDooManuals.net
Section 12 ELECTRICAL SYSTEM
ADAPTER TO
USE
DESS adapter
post (P/N 529 035 684)
RFI DESS adapter
(P/N 278 001 978)
PROTOCOL
TO CHOOSE
DESS
611