Yamaha RX-V779 Owner's Manual page 92

■
Tone Control (Tone Control)
Adjusts the high-frequency range (Treble) and low-frequency range (Bass) of sounds.
Choices
Treble (Treble), Bass (Bass)
Setting range
-6.0 dB to Bypass (Bypass) to +6.0 dB, *0.5 dB increments
• If you set an extreme value, sounds may not match those from other channels.
Adjusting with the front panel controls
a Press TONE CONTROL to select "Treble" or "Bass".
b Press PROGRAM to make an adjustment.
■
YPAO Volume (YPAO Volume)
Enables/disables YPAO Volume or Adaptive DRC.
YPAO Volume (YPAO Vol.)
Enables/disables YPAO Volume. When YPAO Volume is enabled, the high- and
low-frequency levels are automatically adjusted according to the volume so that
you can enjoy natural sounds even at low volume.
Settings
Off (Off) Disables YPAO Volume.
On (On) Enables YPAO Volume.
• YPAO Volume works effectively after the measurement results of "Auto Setup" have been already
saved (p.36).
• We recommend enabling both YPAO Volume and Adaptive DRC when you are listening at lower
volumes or at night.
Adaptive DRC (A.DRC)
Sets whether the dynamic range (from maximum to minimum) is automatically
adjusted when the volume level is adjusted. When it is set to "On", it is useful for
listening to playback at a low volume at night.
Settings
Off (Off) The dynamic range is not automatically adjusted.
Automatically adjusts the dynamic range when YPAO Volume is
On (On)
enabled.
If "On" is selected, the dynamic range becomes narrow at a low volume and wide
at a high volume.
Volume: low
On
Off
Input level
■
Dialogue (Dialog)
Adjusts the volume or perceive height of dialogue sounds.
Dialogue Level (Dialog Lvl)
Adjusts the volume of dialogue sounds. If dialogue sounds cannot be heard
clearly, you can turn up its volume by increasing this setting.
Setting range
0 to 3
Dialogue Lift (Dialog Lift)
Adjusts the perceived height of dialogue sounds. If the dialogue sounds as if it is
coming from below the TV screen, you can raise its perceived height by increasing
this setting.
• This setting is available only when one of the following conditions is met.
– One of the sound programs (except for 2ch Stereo and 7ch Stereo) is selected when presence
speakers are used.
– Virtual Presence Speaker (VPS) (p.56) is working.
(You may hear dialogue sounds from the surround speakers depending on the listening position.)
92
En
Volume: high
On
Off
Input level