To Replace Headlight Bulb; Interlocks And Relays; To Replace Fuse; Smartswitch Ignition System Lights - Craftsman 917.204040 Operator's Manual

TO REPLACE HEADMGHT BULB
1. Raise hood.
2. Remove bulb holder from the hole in the
backside of the grill.
3. Replace bulb in holder and install bulb
holder securely back into the hole in the
backside of the grill.
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
• Check wiring.
TO REPLACE FUSE
Replace with 20 amp automotive-type plug-
in fuse. The fuse holder is located behind
the dash.
SMARTSWITCH iGNiTiON SYSTEM
LIGHTS
The SmartSwitch System is equipped with
courtesy lights that are used to indicate
system functions or faults.
FUNCTIONS
The SmartSwitch Ignition (SSI) Button
(F) will blink blue while waiting for the
correct passcode to be entered. The
SSI button will blink green when tractor
is ready to start and remain solid green
while running.
• The park brake symbol (CO) will be tit if
the parking brake has not been engaged
during a start attempt.
• The blade switch symbol will blink if the
attachment clutch control is not in the
"DISENGAGED" position during a start
attempt.
• The Reverse Operation System (ROS)
button (G) will be lit when Reverse Op-
eration System is in use.
• The Headlight button (H) will remain lit
while headlights are in use.
• During normal operation, the Battery
Indicator button (I) will not be lit.
FAULTS
The SSI Button will blink red for two
seconds if the wrong passcode has been
entered.
The Reverse Operation System (ROS)
button wilt blink when there is a fault
with the Reverse Operation System.
See "Reverse Operation System" in the
Operation section of this manual.
After the first unsuccessful start attempt,
the battery indicator button (I) will blink
for two (2) seconds and then stay lit. This
indicatesthat the battery voltage is below
normal operating level. While engine is
in operation, this light may also indicate
a charging system failure.
• The headlight button will blink when one
or both of the headlight bulbs fail.
• All indicator lights will blink in the event
the engine shuts off for unknown reasons;
for example, if the engine has run out of
fuel.
33