Drip Tray; Descale; To Descale The Unit; Cleaning - Morphy Richards Redefine Instruction Manual

Drip Tray

The Drip Tray Indicator
(8) is full and must be emptied. To empty, pull the drip
tray outwards until it is free from the runners and
discard the contents. CAUTION! The contents of the
drip tray may be hot. Replace the Drip Tray once
emptied ensuring the Drip Tray Cover
correctly.

Descale

This product is fitted with a concealed element that
must be descaled when the Descale Icon
illuminates. Excessive scale can cause the product to
switch off before the end of the heating cycle and may
damage the element invalidating the warranty.
Remove hard scale using a proprietary descaling
product. We recommend Oust Descaler (please follow
the instructions carefully) which may be purchased
from our Helpline or from your local retailer.

To descale the unit:

1
Remove the BRITA Hopper
(19) from the Water Tank (7).
2
Fill the Water Tank to the MAX line with cold water add
the Oust Descaler as per manufacturers instructions.
10
KT131004 MUK REV1.indd 14
(10) indicates that the Drip Tray
(9) is replaced
(16)
(21) and MAXTRA cartridge
3
When the crystals have dissolved, set the unit to heat
1.5 litres of water to 85 degrees.
Do not boil to 100 degrees
4
Leave the Hot Water Dispenser for 10 minutes.
Do not dispense the water!
5
After 10 minutes, dispense the water from the Heating
Chamber into a vessel and discard.
6
Empty the water tank and rinse thoroughly with cold
water.
7
Fill the water tank to the MAX line with cold water, set
the unit to boil 1.5 litres to 100 degrees and dispense
the water. Discard the water and repeat the cycle 3
times
8
Replace the BRITA Hopper and MAXTRA cartridge into
the Water Tank. Fill with fresh water.
9
Press and hold the Start / Stop Button
Button (5) for 5 seconds to reset the descale timer. The
descale icon will extinguish. The Hot Water Dispenser
will reset and the unit will return to ready mode.
10
After 60 seconds of inactivity the Hot Water Dispenser
will enter standby.

Cleaning

Wipe the outside with a damp cloth.
WARNING: Always disconnect the plug from the
mains and allow the appliance to cool before
cleaning.
IMPORTANT: Do not use abrasive cleaners on the
outside of the appliance, as they may scratch the
surface.
(1) and Dispense
18/02/2015 10:34