CAUTION — To reduce risk of injury, charge only Be aware that this tool is always in an operating MAKITA type rechargeable batteries. Other types condition, because it does not have to be of batteries may burst causing personal injury plugged into an electrical outlet.
For Models BFT020F, BFT021F, BFT040F, BFT080F 10. Do not disassemble charger or battery cartridge; and BFT122F (Fig. 1) take it to a qualified serviceman when service or •...
Page 7
Lighting up the lamps (Fig. 6) flicker. CAUTION: Use Makita refreshing adapter to refresh the battery. Do not look in the light or see the source of light directly. CAUTION: Pull the switch trigger to light up the lamp. The lamp A battery cartridge extracted from the charger that has keeps on lighting while the switch trigger is being pulled.
Status of the LED indicator/beeper Function Status Action to be taken LED indicator Beeper Checking the This function works when the battery Replace the battery remaining battery Lights up in power is almost used up. At this time, A long beep with fully charged capacity, red.
ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
(2) Bewaar de accu niet in een bak waarin ook MAKITA oplaadbare accu’s te laden. Accu’s van andere metalen voorwerpen zoals spijkers, andere merken kunnen gaan barsten en verwon- munten e.d. worden bewaard.
Page 12
Als de accu een lange tijd niet is gebruikt of opgefrist moet worden, beginnen de oranje lampjes te flikkeren. Gebruik een Makita opfrisadapter om de accu op te fris- sen.
Page 13
LED-indicator (Fig. 7) Het lampje op het gereedschap toont de volgende functies. Status van LED-indicator/pieptoon Functie Status Te nemen maatregel LED-indicator Pieptoon Deze functie treedt in werking wanneer Automatisch stop- het vooraf ingestelde aandraaikoppel is pen met aan- bereikt en de schroef volledig is aange- Brandt groen draaien draaid.
Page 14
OPMERKING: bij een erkend Makita Servicecentrum of Fabriekservice- Als de bit niet diep genoeg in de mof zit, zal de mof niet centrum, en dit uitsluitend met gebruik van Makita ver- naar zijn oorspronkelijke positie terugkeren zodat de bit vangingsonderdelen.