Table of Contents
Advertisement
On a replacement server:
Procedure
1.
Log in to the server.
2.
Run the nas-preconfig script.
The IP addresses are assigned at this step.
3.
Reboot if you are instructed to by the script.
4.
Log in to the SMU using one of the IP addresses you obtained once they
can successfully connect using ssc localhost.
5.
Use a KVM (keyboard, video, and mouse) or a serial cable to connect to
the serial port on the server.
Alternatively, you can connect by way of SSH using the following
settings:
• 115,200 b/s
• 8 data bits
• 1 stop bit
• No parity
• No flow control
• VT100 emulation
6.
Log in as root (default password: nasadmin), and enter ssc localhost
to access the BALI level command prompt.
7.
Enter evs list to see the IP configuration for the server.
8.
Using a supported browser, launch the Web Manager (SMU GUI) using
either one of the IP addresses acquired from the EVS list output.
9.
Click Yes to proceed past Security Alert, and log in as admin (default
password: nasadmin).
10.
Verify and, if necessary, convert the new server to the model profile
required.
This step requires a separate process, training and equipment. Contact
support if the incorrect model arrives for replacement.
11.
Navigate to Home > Server Settings > Firmware Package
Management to verify and, if necessary, upgrade the new server to the
latest SU release.
12.
Navigate to Home > Server Settings > Cluster Wizard, and promote
the node to the cluster.
13.
Enter the cluster name, cluster node IP address, subnet, and select a
quorum device.
Note that the node reboots several times during this process.
14.
When prompted, add the second node to the cluster.
15.
Enter the physical node IP address, log in as supervisor (default
password: supervisor), and click finish.
Wait for the system to reboot.
16.
Enter smu-uninstall to uninstall the embedded SMU.
Server replacement procedures
Hitachi NAS Platform 3080/3090 G2 Hardware Reference Guide
121
Hide quick links:
Advertisement
Table of Contents
