Eldes ESIM110 Quick Start Manual

In this guide you will learn how to quickly set and run ESIM110 device manually
(using SMS messages for programming). Here are the most important steps:

1. Place SIM card in the holder.

Make sure that PIN code at SIM card is disabled*

2. Connect the circuit.

ESIM 110
AC/DC RELAY GND Z5 Z4 Z3
Power
Opened gates
supply
sensor
Gate controller
3. Set the English language by sending SMS message EN to the number of the SIM card inserted in ESIM110 device.

4. Change the default password to a new one.

Send following SMS message:
0000_PSW_XXXX
In place of XXXX you should enter your new 4 digital password.
All other messages for programming must start with this password.
Underscore symbol '_' in this manual is used to represent space typing.
5. Upload up to five different user mobile numbers which will have access to control the system.
Send the SMS message with the following text
XXXX_NR1:4411111111_NR2:4411111111_NR3:4411111111_NR4:4411111111_NR5:4411111111XXX
It is not necessarily to enter all 5 administrators at once – start by entering the first one (NR1) with your own
or preferred mobile number. The other ones can be added later (for NR2, NR3, NR4 or NR5 users).

6. Upload up to 500 users who will have access to control the gates.

Send SMS message with the following text
XXXX_N:4411111111_4411111111_44...
It is not necessarily to enter all users at once. It is possible to add them at any time later with
same type of SMS message. Up to 10 numbers can be entered sending one SMS message.

7. The system is ready to use.

*1 - PIN code can be disabled by putting SIM card into mobile phone and following proper menu. *2 - Supply Voltage: 10-24 V DC (200 mA max) or 10-24 V AC (200 mA). *3 - User must type
mobile number in the international format (it consist of only those digits that overseas callers must type: 44<area code><local number>) without symbol '+'. E.g. the mobile number of user is +44 (0)
113 xxx xxxx, so the correct format to type is 44113xxxxxxx and the wrong ones – 440113xxxxxxx or 0113xxxxxxx. *4 - device will use default settings set by manufacturer. The settings can be
changed by administrator at any time
QUICK START GUIDE
FOR ELDES
.
1
Connect control connectors of the gate automatics device |
Z2 Z1
to relay contacts and sensors to inputs Z1-Z3.
The system will start in less than a minute and LED indicator will start to blink every 5 seconds.
:
*3
:
*3
*3
ESIM110
USERS
EN
ESIM 110
0000 PSW
ESIM 110
1234
1234 NR1:44
ESIM 110
1111111 NR2
:441111111
1234 N:44
ESIM 110
11111111
441111111