Network; Cannot Connect To The Network; Cannot Select This Unit As The Output Speakers - Panasonic SC-ALL2 Operating Instructions Manual

Firmware updates
"FAIL" is indicated on the display.
≥ The update has been failed. Touch any switch, and then try again.
≥ When using a LAN cable, make sure to connect the LAN cable while the
AC mains lead is disconnected. (l 19)

Network

Cannot connect to the network.

≥ This unit's Wi-Fi security supports WPA2™ only. Your wireless router
must therefore be WPA2™ compatible. For details on the security
supported by your router and how to change the settings, please refer to
the operating instructions or contact your Internet service provider.
≥ If the network is set to be invisible, make the network visible while you
set up the network for this unit or make a wired LAN connection. (l 19)
≥ Make sure that the multicast function on the wireless router is enabled.
≥ Depending on the routers, WPS button may not work. Try other
methods. (l 12)

Cannot select this unit as the output speakers.

≥ Make sure that the devices are connected to the same network as this
unit.
≥ Reconnect the devices to the network.
≥ Turn off and then on the wireless router.
- 50 -