Controlling Ts-590Sg From A Pc On A Remote Site; New Arcp-590G (Amateur Radio Control Program For Ts-590Sg) Freeware - Kenwood TS-590SG Manual

8.2.5 Controlling TS-590SG from a PC on a Remote Site

Remote Station (PC that remotely
Software
Control
ARCP-590G
signal
ARVP-10R or
Audio signal generic VoIP
software
Caution:
◆ When the USB connector is used for input/output of the audio signal on the host station, ARUA-10 is not required neither.
8.3 New ARCP-590G (Amateur Radio Control Program for TS-590SG)
Freeware
ARCP-590G (Amateur Radio Control Program for TS-590SG) is a software that enables control of the TS-590SG from a PC.
ARCP-590G can be downloaded from the following website for free.
URL for downloading ARCP-590G:
http://www.kenwood.com/i/products/info/amateur/software_download.html
As with ARCP-590 for the TS-590S, the new ARCP-590G program is designed to control virtually all of the functions on
the TS-590SG transceiver.
ARCP-590G is a software exclusively for TS-590SG. ARCP-590G cannot be used to control TS-590S. This is to allow
users using both the TS-590SG and TS-590S to control the transceivers independently, and to ensure full performance
controls the transceiver)
Hardware
-
The microphone
and speaker
connected to a
PC
Figure 8-1 Main Window of ARCP-590G
EXPANSIVE APPLICATION SOFTWARE 08
Host station (PC that is located near the
Type of
Connection
Software
ARHP-590G
Network
ARVP-10H or
generic VoIP
software
TS-590SG)
Hardware
* Connected to
the COM or USB
connector
* Connected to
the ACC2 or USB
connector
57