Table of Contents
Advertisement
OPERATION
AC CONNECTION
CHARGING
THE BAITERY
PACK
1. Insert the small plug on the end of the AC adaptor cord Into the 9V DC
IMPORTANT
NOTE:
lack on the back of the base stat!on.
The battery pack must ba charged for a full 12 hours before the cord-
2
Plugthe ACadaptormto
an ACwalloutlet.
fass phone is used for tha first fima. Do not use the phona before
charging the battery pack.
NOTE:
If 6 long beeps sound when the AC connecfiins are made, the message
1
tape has not been inserted.
2
To power outlet
<
(AC241JV, 50fiz,
~~-~
~+s' <,,~~
I?_lp
v
'o-
/'
/
H
U'
------
/z
*
AC adaptor
<
,)
(Model No. KR0617)
NOTE:
USE ONLY SANYO AC ADAPTOR
MODEL NO. KR0617
(APPROVAL
NO. Q941 13)
PHONE LINE CONNECTION
NOTE:
Please make sure fhst the handset battery is fully charged before connecting
the phone line cable.
qiL3
Place the handset on the base
station and charge it for a f!l!
IaQurs.
In order to verify that the
//
>*
handset battery is fully
chsrged...
a) Remove the handset fmm
.
%
the base station.
b) Check to see that the BAIT
LOW mdlcator IS off.
NOTE:
If the BATT LOW indcator
'&
hahts. even after charaina
f;r a full 12 hours, ref;r t;
the troubleshooting guide on
page 41.
c) After initial setup, recharge
the handset banery by
placing it on the base station
cradle whenever the BAIT
LOW indmator hghts.
Replacement banery packs are
available from an authorized
Sanyo service center.
ReDlacemmt
bafferv mck D@
BAIT
LO
mdcator
nUkbOC SANYO 3N~2"70W"
Use of other brand or type baner-
!es may cause serious damage or
equipment maituntilons.
NOTE;
6
When batteries are discharged,
they must be disposad of in a safe
manner that compbes wdh all
:.
applicable laws.
SANYO 3N-2701W
BASE STATION
VOLUME
CONTROL
Set the VOLUME control to the
correct poafin
to give you the
desired sound bvel. If you set the
l,.
mm–
VOLUME control to the minimum
/
position, no sound is heard fmm
the speaker.
,
VOLUME
control
t!
WARNINGS
-
This cordless telephone may, on some longer fines, have difficuiiy
handing over to another devk
mnr!%cted to the same fine.
-
Immediately disconnect the equipment should it become physically
damaged, and arrange for its disposal or repair.
-
The operation of this equipment on the same line as telephones or other
equipment w~h audible warning devices or automate ring detectors will
give rise to tefl tinkle or noise and may causs falsa tripping of the nng
detector. Shou!d such ptilems
occur, the user is not to contact Telecom
FauRs Service.
–3–
Advertisement
Table of Contents
Troubleshooting
