Rechargeable Battery Pack; Troubleshooting - DeWalt XR LI-ION DCGG571 Original Instructions Manual

EN GLI SH

Rechargeable Battery Pack

This long life battery pack must be recharged when
it fails to produce sufficient power on jobs which
were easily done before. At the end of its technical
life, discard it with due care for our environment:
• Run the battery pack down completely, then
remove it from the tool.
• Li-Ion cells are recyclable. Take them to your
dealer or a local recycling station. The collected
battery packs will be recycled or disposed of
properly.

Troubleshooting

Problem
Unable to pull back rod
Unable to push rod forward
No grease when trigger is pulled
Grease appears in relief valve
Motor does not run when trigger
is pulled
Grease leaks out of the back of
the grease tube
16
Possible Cause
Vacuum build up
Pressure build up
Rod is still connected to
plunger
Grease tube is empty
Air pockets in the grease tube Refer to Purging Air Pockets.
Check valve is clogged
Filter is clogged
Zerk fitting is blocked
Battery
Rubber seal is flipped the
wrong direction
Possible Solution
Unscrew the purge valve to release
vacuum.
Unscrew the purge valve to release
pressure.
Rotate grease tube handle 90 degrees
to disengage it.
Add grease.
Refer to Cleaning Contamination
from the Check Valve.
Refer to Cleaning Contamination
from the Filter.
Disconnect coupler from fitting, clean
zerk fitting and grease path.
Make sure the battery is fully charged.
Refer to Preparing the Grease Gun
for Suction and Filler Pump Filling.