Electrical Safety; Using An Extension Cable; Variable Speed Trigger Switch - DeWalt XR LI-ION DCGG571 Original Instructions Manual

h. Flexible hose safety spring guard
i. Flexible hose coupler
j. Grease tube
k. Grease tube cap
l. Grease tube handle
m. Grease tube rod
n. Grease tube assembly
o. Retaining slot
p. Battery
q. Battery release button
r. Rubber feet
s. Hose clip
t. Shoulder strap mount
u. Shoulder strap clip holes
v. Filter
Figure 5
w. Pressure relief valve
x Purge valve
y. Check valve
z. 1/8" NPT fill port
aa. 1/8" NPT fill port plug
INTENDED USE
This grease gun is designed for professionally
dispensing lubricant.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
This grease gun is a professional power tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• Young children and the infirm. This appliance
is not intended for use by young children or
infirm persons without supervision.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.

Using an Extension Cable

An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical Data). The minimum conductor size
is 1 mm 2 ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
LED Worklight (fi g. 1, 3)
There is an LED worklight (d) located on the top cap
(f). The worklight is activated when the trigger switch
is depressed and when the LED worklight button
(e) is in the ON position. When the LED worklight
button is in the OFF position, the LED worklight
will not turn on when the trigger is depressed. The
worklight will automatically turn off 20 seconds after
the trigger switch is released. If the trigger switch
remains depressed, the worklight will remain on.
NOTE: The worklight is for lighting the immediate
work surface and is not intended to be used as a
flashlight.

Variable Speed Trigger Switch

(fi g. 1, 4)
LOCK-OFF BUTTON AND TRIGGER SWITCH
Your grease gun is equipped with a lock-off
button (b).
To lock the trigger switch, press the lock-off button
as shown in Figure 4. Always lock the trigger switch
(a) when carrying or storing the tool to eliminate
unintentional starting. The lock-off button is coloured
EN GL IS H
11