Troubleshooting - DeLonghi ECAM44.66X ELETTA Instructions For Use Manual

FILL BEANS CONTAINER
INSERT INFUSER ASSEMBLY
INSERT TANK
GENERAL ALARM
EMPTY CIRCUIT, FILL CIRCUIT
HOT WATER
Press OK
REPLACE FILTER
SET DIAL TO CLEAN
INSERT WATER SPOUT
INSERT MILK CONTAINER

TROUBLESHOOTING

Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM
The coffee is not hot
The coffee beans have run out.
The pre-ground coffee funnel (A4) is clogged.
The infuser (A15) has not been replaced after
cleaning.
The tank (A16) is not correctly in place.
The inside of the appliance is very dirty.
The water circuit is empty
The water softener filter is exhausted.
Milk has been delivered recently and the tubes
inside the milk container must be cleaned.
The hot water spout is not inserted or is
inserted incorrectly.
The milk container is not inserted correctly.
POSSIBLE CAUSE
The cups were not preheated.
The infuser has cooled down because
2/3 minutes have elapsed since the last
coffee was made.
A low coffee temperature is set.
Fill the beans container (fig. 14).
Empty the funnel with the help of a brush as
described in the section "Cleaning the pre-
ground coffee funnel" (page 16).
Insert the infuser as described in the para-
graph "Cleaning the infuser" (page 16).
Insert the tank correctly and press as far as it
will go.
Clean the inside of the appliance thoroughly,
as described in the section "Cleaning" (page
15). If the message is still displayed after
cleaning, contact a service centre.
Press OK (B3) and deliver water from the spout
(D4), until it flows out normally.
Replace the filter or remove it as described in
the section "Water softener filter" (page 20).
Turn the froth adjustment dial to CLEAN (fig.
25).
Insert the water spout (D4) as far as it will go.
Insert the milk container (fig. 23) as far as it
will go.
SOLUTION
Warm the cups by rinsing them with hot
water (Please note: you can use the hot water
function).
Before making coffee, use the special function
to rinse and heat the infuser (page 10).
Set a higher coffee temperature in the menu
(page11).
21